FEATURES
10HP
20HP
30HP
40HP
50HP
90HP
The Profiler’s nozzles telescope up and down to profile the contour of each vehicle, delivering maximum pressure output on the surface of each vehicle. The Profiler nozzles provide up to 30% more output pressure on the surface of the vehicle without any additional horse power. The Profiler uses a simple, self-contained photo-eye and control circuit solution that is dependable and easy to operate. It uses simple air cylinders that drive the nozzles up and down for smooth control movements. No complicated drives, shafts or belts. The nozzle extensions are made of soft, pliable car wash cloth that keeps the dryer and vehicles passing under it damage-free in the unlikely case of a collision between the nozzle and a vehicle.
The Air One™ Profiler™ 40 H.P. Dryer is designed specifically to evacuate rinse water out of the drip rails of vehicles and to dry the side windows and vertical surfaces. The top two air producers telescope up and down to get as close to each vehicle’s surface as possible. Use the 30 H.P. Profiler to move the bulk of the rinse water off the horizontal surfaces. Follow up with the 40 H.P. Profiler to address side windows and vertical surfaces. Then, for best results, use a second 30 H.P. Profiler to finish the drying process. What do you get for 100 H.P.? When you go with the Profiler Series, you get bone dry cars.
Nozzles extend to reach closer to the surface of each vehicle.
Nozzles retract for taller surfaces like the roof.
Front and rear nozzles move up and down independently.
Nozzles extend down again to dry the lower horizontal surfaces, like hoods and toneau covers.