Air One Profiler Dryers work best at the end of the wash tunnel with adequate drip space between the final rinse arch and the first dryer air producer. The Profiler usually is the first dryer to meet the cars.
Air One Profiler Dryers produce the "dry" part of "Clean, Shiny, Dry" cars. The Air One Profiler 30HP uses (3) 10HP premium efficiency motors and harmonically balanced air producers to deliver 5 producers worth of work in an efficient, 30hp package. The Air One Profiler 40HP uses (4) 10HP premium efficiency motors to dry the sides.
Damage-Free Cloth Nozzle Extensions.
Color Skinz™ snap-on structure wrap.
92% Premium Efficiency, UL approved, Marathon® Blue Chip™ motors.
Each Air Producer uses one 10 HP electric motors 208/230/460V.
Surprisingly quiet, harmonically balanced air producers. 88dBa or less!
Compact Design packs drying power into a small footprint and saves space.
Molded Plastic Dryer Housing is available in multiple colors - Yellow, Black, Blue, Red.
The Profiler’s nozzles telescope up and down to profile the contour of each vehicle, delivering maximum pressure output on the surface of each vehicle. The Profiler nozzles provide up to 30% more output pressure on the surface of the vehicle without any additional horse power. The Profiler uses a simple, self contained photo-eye and control circuit solution that is dependable and easy to operate. It uses simple air cylinders that drive the nozzles up and down for smooth control movements. No complicated drives, shafts or belts. The nozzle extensions are made of soft, plyable car wash cloth that keeps the dryer and vehicles passing under it damage-free in the unlikely case of a collision between the nozzle and a vehicle.
Nozzles extend to reach closer to the surface of each vehicle.
Nozzles retract for taller surfaces, like the roof.
Front and rear nozzles move up and down indepedently.
Nozzles extend down again to dry the lower horizontal surfaces, like hoods and tonneau covers.
40HP Air One™ Profiler™ Dryer with Color Skinz™ Arch
The Air One™ Profiler™ 40 HP Dryer is designed specifically to evacuate rinse water out of the drip rails of vehicles and to dry the side windows and vertical surfaces. The top two air producers telescope up and down to get as close to each vehicle’s surface as possible. Use the 30HP Profiler to move the bulk of the rinse water off the horizontal surfaces. Follow up with the 40HP Profiler to address side windows and vertical surfaces. Then, for best results, use a second 30HP Profiler to finish the drying process. What do you get for 100HP? When you go with the Profiler Series, You Get Bone Dry Cars.
Dryer Housing Color Options: Yellow, Blue, Black, Red.